Hello experts, (beginner here)
I have a test stand with 4 axis (x,y,z1,z2) connected to EL7041 motor terminals on CX5130. The problem I am facing is, Z2 axis should switch the end switch to continue with the process, but it stops close to switch. (doesnt switch) and the process stops. (the motor increments in the NC online). So, I want to change the default home position values in the MC_Home. (the value written there is "1E+307").
Question: How can I change the value of the z axis home position. Tried to force in the program but not working. Please help. Thank you.
NC position.JPGPosition.JPGgvl position.JPG
I have a test stand with 4 axis (x,y,z1,z2) connected to EL7041 motor terminals on CX5130. The problem I am facing is, Z2 axis should switch the end switch to continue with the process, but it stops close to switch. (doesnt switch) and the process stops. (the motor increments in the NC online). So, I want to change the default home position values in the MC_Home. (the value written there is "1E+307").
Question: How can I change the value of the z axis home position. Tried to force in the program but not working. Please help. Thank you.
NC position.JPGPosition.JPGgvl position.JPG